Watch These Exciting Episodes Of Black Gold Here… Continue
Added by Drilling Ahead on July 26, 2010 at 9:00pm —
After you complete shut in procedure while tripping, there is following information that must be recorded before making any decision on how to kill the well.
Shut-In Casing Pressure (SICP): Read and record… Continue
Added by Rachain Jetjongjit on July 21, 2010 at 1:30am —
Tripping out of the hole is a critical operation, which drilling team must keep close eye on well control situation that can
occur anytime. Wellbore monitoring and hole filling equipment and must be working properly so that the kick can be quickly detected. You must be aware of and prepared for the well… Continue
Added by Rachain Jetjongjit on July 17, 2010 at 7:30pm —
There are several figures that must be recorded after the well has been properly shut in in case of a well control situation.
Shut-In Casing Pressure (SICP): Read and record the shut-in casing pressure (casing gauge).
In order to get the proper pressure reading, the casing gauge should be… Continue
Added by Rachain Jetjongjit on July 11, 2010 at 9:30pm —
While drilling, drilling team must be carefully check for well control indicators and if the positive kick indicator(s) indicated, crew must instantly know how to shut in the well in correct manner. The steps below, called "3S" shut-in procedures, demonstrate how to properly shut the well in while drilling.
Drilling shut in procedures (3S) – HARD SHUT IN… Continue
Added by Rachain Jetjongjit on July 2, 2010 at 11:30am —